So I took that stock apart on that tiny little double barrel. Was much easier than I thought. They used some small bolts and square nuts and ground them down. I simply drill the bolt out of the nut and tapped them out. There was this brown stuff over everything that I thought was epoxy but I think it's just stain. The front bolt went between the 2 main springs and had to be removed before the stock could be taken off. That means I wont be able to run a dowel all the way through, I'll just plug each side. I'll run a dowel through the other hole and may drill another in at an angle and use a smaller dowel. I ordered some acra glass and walnut dowels. I probably also drill some very shallow holes inside the break to let the acra glass get a good hold. This will certainly not look pretty when I'm done. I'm sure I could have made it look much better if it wasn't already repaired. Thankfully they didn't use glu or epoxy, It would have been much harder to get apart.
![Image]()
![Image]()
I took some other things apart to clean it too. The bolt on the bottom is the stock bolt and it's bent. The bolt on the top holds the barrels on and it's also bent but after looking at it I wonder if its supposed to be that way. I'm thinking it may be an adjustment for the headspace?
![Image]()
I took some other things apart to clean it too. The bolt on the bottom is the stock bolt and it's bent. The bolt on the top holds the barrels on and it's also bent but after looking at it I wonder if its supposed to be that way. I'm thinking it may be an adjustment for the headspace?
