National Gun Forum banner

1 - 4 of 4 Posts

·
Gunbiddler.com
Joined
·
19 Posts
Discussion Starter #1
Ok, so I'm thinking about building a mini cannon at my metal shop. I have a piece of solid round 2" brass I'm gonna try and do the barrel out of. Any one ever built one or Know anything about them? If it works I'm gonna try and sell them. I've seen them online for around $2000 and I don't think I'll have anymore than $500 in it after I'm done.
 

·
Registered
Joined
·
7,193 Posts
I don`t think I would want the liability issues attached if some bozo shoots a projectile out of one and kills himself or someone else. Lawyers would be all over it. JMO.
 

·
Registered
Joined
·
826 Posts
Better make sure you get all the paperwork since you will be making a class 3 destructive device.
 

·
Gunbiddler.com
Joined
·
19 Posts
Discussion Starter #4
Well the liability issue doesn't concern me. I have an FFL and sell firearms. On the Class Three issue, I'm not sure that it is. When I tried to looked up the the possible rules for it, all I could find was that only weapons that fire a cartridge round are ruled by the law. So I think it would fall under the black powder category.
 
1 - 4 of 4 Posts
Top