National Gun Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I just got back home for christmas and I was doing my dad a favor by replacing the springs on our WWII M-1 Garand. Me being an idiot I decided not to follow the directions very closely and I removed both of the pins on the trigger assembly with the hammer cocked...Now its stuck. I can almost get the one pin in as seen in the picture but the pin that the screwdriver is currently taking the place of wont go in. I was just hoping really that anybody here knew of any solution to this problem because if the hammer wasn't cocked it would all fall out very easily. And M-1 Garand forum looks pretty dead so I figured I come here.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top