National Gun Forum banner
1 - 4 of 4 Posts

·
Aim true !
Joined
·
12,149 Posts
Discussion Starter · #1 ·
A few shots i got a puff of air in my face. Yesterday when i was shooting it. It always had a deep strike. These were light cast data loads. It's at .084 now according to my calipers. It cleared the .095 slot on the tool. After adjusting it. But hit the .075 one on the tool. The pin is in as far as it will go.
 

·
Registered
Joined
·
15,182 Posts
I had to adjust one on one of mine after i got it. Don't recall if it was too short or too long but i checked it when i got it.
 
  • Like
Reactions: Coalcracker

·
Aim true !
Joined
·
12,149 Posts
Discussion Starter · #4 ·
I use CCI i do belive they are supposed to be the hardest. Next time i shoot a Tula round i'll look at the primer. I did shoot some factory PPU yesterday. I didn't de-cap them yet. I'll take a look at them too.
 
1 - 4 of 4 Posts
Top