National Gun Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
i had an idea to use cut down 45 colt brass to use in my 455 webley revolver. lee sells these 300 grain bullet molds that i was also thinking about using (i could post a link with permission). i think if i dont use too much powder this would be a cool bullet to shoot out of the thing. any insight would be greatly appreciated. thanks.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top