National Gun Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Shotgun Discussion
    Hey everyone, first post here and totally new to the forum. I got a question about my Remington 870 Wingmaster. I bought a new 18" barrell for it and a mag extention tube and took it out to the pits and there seems to be a bit of a problem. It fires with massive kickback, before it would shoot...
  2. Firearm Accessories
    I recently purchased a gun light for my shotgun <link>, but quickly ran into an issue with the switch being too long for the picatinny railing available. This wouldn't be an issue except for the fact that the mounting hardware for the switch butts up against the opposite ends instead of being...
  3. Rifle Discussion
    So after cleaning this old Norinco SKS of cosmoline and oiling it up, I went to reassemble the darn thing and it went together just fine up until I went to lock it up with the takedown pin. Lo and behold the pin got stuck just shy of going through the opposite end, i.e. there's a few millimeters...
  4. New Members Introduction
    hello everyone sorry if this has been asked before. i have been searching everywhere but cant find a direct answer for my specific question. so ok, the very first pistol i bought is a 9mm tuarus pt111 millenium pro, jan 2014 will put the purchase at 10yrs ago. for the most part it has been...
  5. General Gunsmithing
    I was looking at building an AK-47 from a Bulgarian AK-47 Milled kit, but found out that the kit NEEDED a milled receiver. Is this true or can I get away with a stamped receiver and put a new AKM rear trunnion for stamped receivers. I can't find a front trunnion anywhere so could I get away with...
  6. General Gun Discussion
    hi everyone ive been searching my question & cant find an answer so here i am. i just bought a rock river ar-15 5.56 & the magazine it came with is a 30 round thermold magazine (its plastic in case you need that info) i can pull the charging handle back, release & it only goes forward about a...
  7. Gun Related Pictures
    I just got an ak but dont know much about them yet i was playing around with the bolt that pulls back underneath the clip and it got stuck in the open position is this a bad thing? Should i force it back to the closed position or should i just leave it like that
1-7 of 7 Results
Top