National Gun Forum banner
Showcase cover image for 80 Percent Arms Easy Jig Gen 3  Defect

General Information

I recently got my 80% arms easy jig generation three model, I milled an AR-10 80% lower and noticed something was off too much material was being removed on one side of the lowers wall. After careful inspection I realized that the top jig plate is missing a little ear that guides the router pins while milling. In the pictures below you can see the jig plate I have has no ear. And the other picture shows the little ear that the jig plate is supposed to have, I got that image from the 80% arms website. You can see a big difference in the two jig plates. Make sure that you pay attention to the top of the jig plate before you start machining anything.



There are no comments to display.